You’ re fine to pr oceed with the update. There are different messages shown based on what the system update is going to apply.ĭo NOT accept the update because this is telling you that the system is going to attempt a complete update which alters bootloaders and it will also burn eFUSEs. Transfer the $$ystemUpdate folder (the one you renamed in Step 2) to the root of a FAT32-formatted USB stick (I recommend 512MB+).Ĭonnect your USB stick to your console, power it on and accept the update when prompted. This small tutorial will help you install them ( ensure your Kinect hardware is connected before you begin or you will be prompted to update again once you connect it!).ĭownload the USB system update from here ( remember to check that the system update you download matches your JTAG/RGH kernel version – go to System Settings>Console Settings>System Info and read where it says Dashboard: 2.0.XXXXX.0, where X = your console’s current dashboard/kernel version).Įxtract the $systemupdate folder from the archive with 7-Zip or similar and rename it to $$ystemUpdate. So, you have a JTAG or RGH system, but no Avatars or Kinect? Also, ensure that you have DashLaunch installed and configured. Before you proceed, ensure you have an internal hard drive connected with enough space for the update (I think somewhere around 128MB is required). To change the dashboard/kernel version of your JTAG/RGH console, you build a new image with J-Runner or similar. Subscribe to our FDOT Contact Management Subscription Service to receive the most current notices, bulletins, memoranda, and other important information.This is NOT for updating your JTAG/RGH dashboard/kernel, this is for installing Avatar/Kinect data ONLY.
Information on the use of Standard Plans within FDOT Contract Plans. See the FDOT Design Manual (FDM), Chapter 115, for additional
0 kommentar(er)
